Installing the seat frame
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Position and fasten all mounted parts on the seat frame (1) .
- Correctly position the seat frame (1)
.NOTE: The operations shown only for one side must be carried out on both sides.
- Replace screws (1)
.
Parts: Screws
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Seat frame to backrest frame | ||
| Screw Replace screw. |
tightening torque | 44 Nm |
Follow-up work
- Refer to INSTALLING THE SEAT COVER WITH CUSHION FOR THE DRIVER'S SEAT .
- Refer to INSTALLING THIGH SUPPORT .
- Refer to INSTALLING THE BACKREST COVERING WITH THE CUSHION .
- Refer to INSTALLING THE INNER COVER ON THE FRONT SEAT .
- Refer to INSTALLING OUTER COVER ON FRONT SEAT .
- Refer to INSTALLING THE HEAD RESTRAINT .
- Refer to INSTALLING THE REAR PANEL ON THE FRONT SEAT BACKREST .
- Refer to AFTER CONTINUING WORK ON THE FRONT SEAT: DISCONNECTING THE FRONT SEAT FROM THE WIRING HARNESS OF THE VEHICLE AND REMOVING IT FROM THE UNIVERSAL SEAT MOUNT .
- Refer to INSTALLING DRIVER'S SEAT .