Install the tail light on the side panel
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
Check
- Check seal (1) for damage, replace if necessary.
- Check threaded inserts (2) for damage.
Result
» The threaded inserts are damaged.
Measure
- Replace tail light.
- Contact surfaces (1) on tail light (2) must not be damaged or missing.
Missing contact surfaces (1) could cause paintwork damage.
- Connect the connector (1) to the tail light on the side panel (2).
The connector (1) must engage audibly.
- Lock, lock (3) in the arrow direction.
- Position tail light on the side panel (1) on the side panel (2).
- Position the nut (1).
- Position tail light on the side panel (1) toward the front - at top.
- Move the contact surfaces (2) of the tail light on the side panel (1) upwards to contact.
- Hold the tail light on side panel (1) in position.
- Tighten nut (1).TIGHTENING TORQUE SPECIFICATION
Tail light to side panel to body Combination hexagon nut Tightening torque 4 Nm - Fit the nuts (3).
- Align the tail light on the side panel (1) to the connection line (2).
The alignment is done by means of threaded inserts (4) on the tail light on side panel (2).
- If applicable, correct the position of the rear light on the side panel (1) by twisting the threaded inserts (4).
- Tighten nuts (3).
TIGHTENING TORQUE SPECIFICATION
| Tail light to side panel to body | ||
|---|---|---|
| Combination hexagon nut | Tightening torque | 4 Nm |
Follow-up work
- Refer to INSTALLING TRIM IN THE BOTTOM WATER CHANNEL .
- Refer to PARTIALLY INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to INSTALLING THE LED IN THE LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE COVER OF THE LUGGAGE COMPARTMENT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE FRONT STORAGE SHELF .