Remounting (basic) the control unit for the Front Light Electronics (FLE)

Removing the control unit for the Front Light Electronics (FLEL) (LED basic) 

• Loosen screws (1).
• Feed out the control unit for the Front Light Electronics (FLEL) (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock plug connection (1) and disconnect.
• Remove the control unit for the Front Light Electronics (FLEL) (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the Front Light Electronics (FLEL) control unit (LED basis) 

• Check seal (3) for damage and replace if necessary.
• Position the Front Light Electronics (FLEL) control unit (2).
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the Front Light Electronics (FLEL) control unit (2) and correctly position.
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.