Replacing lock cylinder
WARNING:
Working on 12 V electrical system
.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING OUTER WINDOW CHANNEL STRIP .
- Refer to RELEASING THE FRONT DOOR WINDOW GLASS .
- Refer to REMOVING THE FRONT MODULE BRACKET .
- Refer to REMOVING FRONT DOOR WINDOW GLASS .
- Refer to PARTIALLY REMOVING ELECTRICAL POWER WINDOW OF THE FRONT DOOR .
- Refer to REMOVING FRONT DOOR HANDLE .
- Refer to REMOVING THE OUTSIDE DOOR HANDLE SUPPORT WITH THE LOCKING CYLINDER .
- Detach the locking rod (1) .
- Loosen screw (2)
.
- Twist the lock cylinder (1)
in the clockwise direction and remove it from the outside door handle support.
- Replace the lock cylinder (1)
.
Parts: lock barrel
- Screw the lock cylinder (1)
counterclockwise into the new outside door handle support.
- Hook the locking rod (1) into the lock cylinder.
- Tighten down screw (2) .
Follow-up work
- Refer to INSTALLING THE OUTSIDE DOOR HANDLE SUPPORT WITH THE LOCKING CYLINDER .
- Refer to INSTALLING THE FRONT DOOR HANDLE .
- Refer to INSTALLING THE POWER ELECTRIC WINDOWS OF THE FRONT DOOR (PARTIALLY REMOVED) .
- Refer to INSTALLING THE FRONT MODULE BRACKET .
- Refer to INSTALLING FRONT DOOR WINDOW GLASS .
- Refer to INSTALLING THE FRONT DOOR TRIM PANEL .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to ADJUSTING THE FRONT DOOR WINDOW GLASS .
- Refer to INSTALLING OUTER WINDOW CHANNEL STRIP .