Installing the intake plenum

NOTE: RISK OF DAMAGE
Improper routing of cables and wiring harnesses .
Trapped, crushed or damaged cables may cause short circuits and malfunctions .

NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws in the sequence (1) to (7) in 360 degree increments.

TIGHTENING TORQUE SPECIFICATION

Intake plenum to cylinder head
M6	Tightening torque	10 Nm

The coolant line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1) .

TIGHTENING TORQUE SPECIFICATION

Intake plenum to support
M6X25	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATION

Intake plenum to support
M6X25	Tightening torque	8 Nm

The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Check the sealing ring (1) for damage and replace the tank ventilation line if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the tank vent line (2) .
The locks (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing rings (1) for damage and replace the tank ventilation line (2) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the tank vent line (3) .
The locks (2) must engage audibly.
Secure the tank vent line (3) to the clamp (4) .
Connect connector (1) and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing rings (1) for damage and replace the tank ventilation line (2) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the tank vent line (2) .
Secure the tank vent line (2) to the clamp (3) .
Tighten down screw (1) .

TIGHTENING TORQUE SPECIFICATION

Tank vent line to intake plenum
Oval-head screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the tank vent line (1) .
Secure the tank vent line (1) to the clamp (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the wiring harness section (1) for the injectors and the ignition coils on the cylinder head cover (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the wiring harness section (1) for the injectors and the ignition coils.

The locks (arrows) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install the wiring harness section (2) for sensor system 2.
The locks (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing ring (1) for damage and, if necessary, replace it.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install charge air line (2) .
Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATION

Charge air line to throttle valve
M6x30	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work