Installing center bulkhead lower part
- Position the center cowl lower part (3) .
- Tighten the nut (2) and the bolts (1) .
TIGHTENING TORQUE SPECIFICATION
| Bulkhead lower part on body | ||
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .