Removing the rear window (rear window broken)

NOTE: TECHNICAL INFORMATION
The seal of the lower rear window is no longer necessary. A damaged seal must be removed.
The rear window is installed without a seal .

NOTE: TECHNICAL INFORMATION
The following procedure forms the basis for these repair instructions and must be observed without fail.
For additional information see: GENERAL PROCEDURE FOR THE DISASSEMBLY AND INSTALLATION OF BONDED WINDOW GLASS .

Preliminary work

Refer to REMOVING THE TRIM PANEL FOR THE REAR LEFT AND RIGHT WATER CHANNEL .
Refer to REMOVING BOTH C-PILLAR TRIM PANELS .
Removing the trim of the auxiliary brake light.

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen the clips (1).

Release the locks (2) and remove the trim of the 3rd brake light (3).
Refer to REMOVING THE BRAKE LIGHT .

CAUTION: Broken glass due to damaged front/rear or side windows
Injury hazard!

Wear safety goggles and cut-resistant protective gloves.

Unlock plug connection (1) and disconnect.
Secure cable to rear window with adhesive tape.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen nut (1) .
Remove the cable (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (1) and disconnect.
Remove the cable (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Separate the rear window with a suitable tool (for example, a special cutter with an oscillating knife or special tool 0 410 807 ).
Remove all glass splinters (also under the seats).
Check the safety belts:
- Condition of belt strap
- Function of the roll-up mechanism
- Seat belt locking reel
- seat belt buckle
Replace any damaged or defective parts.
If necessary, remove the glass splinters from the housing case of the roller cover for luggage compartment.
Check the roll-up mechanism of the roller cover for luggage compartment if necessary.
Remove the adhesive bead on the body using special tool 0 410 436 and clean the adhesive area.