Install EMF actuator

• EMF actuator (1)  Carefully fit controller drive until gearing engage and EMF actuator rests flush on brake caliper.
• If necessary, turn the EMF actuator slightly until the bore and the screw thread are aligned.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the holder (4)  and position and tighten the bolts (3)  .

• Connect plug (1)  .
• Attach the brake hose (2)  in the holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to AFTER EMF ACTUATOR REPLACEMENT: PUTTING ELECTROMECHANICAL HOLDING BRAKE INTO OPERATION .