Install front brake hose

• Fit and tighten brake hose (1)  on brake caliper.

If necessary, grip at knurling (2)  .

Never twist brake hose and avoid all contact with components attached rigidly to the body.

Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the brake hose in the holders (3)  .
• Attach and tighten union screw (1)  .
• Hold on to square shaft, if necessary (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to ATTACHING THE FRONT LEFT WHEEL .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .