For reusing: Removing the adhesive bead
- Clean the windshield in the area of the adhesive bead (1) .
| Consumable | ||
|---|---|---|
| Cleaning agent R2 | 500 ml | 83190417324 |
- After cleaning, allow to air out.
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | |
|---|---|
| Window glass or painted panel without residual adhesive bead | 5 min |
| Body with adhesive bead | 15 min |
- Remove adhesive bead (1)
on the rear window just before the adhesion using standard tool (2)
,
Standard tool:
Pinchweld scraper set
Pinchweld scraper set
81 62 0 410 436
NOTE:
TECHNICAL INFORMATION
Do not touch the adhesive bead after cutting or allow it to come into contact with cleaning agents.
Do not touch the adhesive bead after cutting or allow it to come into contact with cleaning agents.
- Prepare pinchweld scraper (2) as pictured.
- Cut back adhesive bead (1) on rear window (3) .
TECHNICAL DATA SPECIFICATION
| Residual height of the adhesive bead | |
|---|---|
| Residual height of the adhesive bead | max. 1 mm |