Installing the rain-light-solar-condensation sensor

Check

NOTE: RISK OF DAMAGE
Damage to silicone surface .
A damaged silicone surface can lead to malfunctioning of the rain-light-solar condensation sensor .

Do not tap or damage the silicone coated surface on the rain-light-solar condensation sensor.
After loosening lock, wait approx. 30 min. at 20°C for silicone surface to relax.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Silicone surface is damaged (1) .

Measure

Carefully clean windshield in contact area (1) of rain-light-solar-condensation sensor.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the rain-light-solar-condensation sensor (2) in the holder and press on the center of the retaining springs (1) .
To lock it in place, press down the retaining springs (1) on each side one after the other.

Courtesy of BMW OF NORTH AMERICA, INC.

Check

Check contact surface externally for air pockets.
Visible shades (1) are not air pockets, rather the optical element of the rain-light-solar-condensation sensor (2) . The shades (1) do not represent a functional limitation.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Contact surface exhibits air pockets.

Measure

Courtesy of BMW OF NORTH AMERICA, INC.