Replacing the module bracket
WARNING:
Working on 12 V electrical system
.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to PREPARING THE SPECIAL TOOL .
- Refer to REMOVE DOOR TRIM PANEL .
- Refer to PARTIALLY REMOVING THE COVER ON THE INTERIOR WINDOW FRAME .
- Refer to REMOVING THE EXTERIOR MIRROR .
- Refer to REMOVING THE OUTER WINDOW CHANNEL STRIP .
- Refer to REMOVING THE FRONT MODULE BRACKET .
Removing flat motor for the front power windows
- Unlock plug connection (1) and disconnect.
- Loosen screws (2).
- Remove the flat motor for the front power windows (3).
Remove the loudspeaker on the front door
- Loosen screws (1).
- Unlock and disconnect plug connections (2).
- Remove the loudspeaker on the front door (3).
Installing the loudspeaker on the front door
- Connect connectors (2) and lock.
- Position the loudspeaker on the front door (3) and tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Loudspeaker in door to module bracket in door | ||
|---|---|---|
| Oval-head screw for thermoplastic | Tightening torque | 2 Nm |
Installing flat motor for front power windows
- Installing flat motor for front power windows (3).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATION
| Flat motor to module bracket in door | ||
|---|---|---|
| Oval-head screw for thermoplastic | Tightening torque | 3.5 Nm |
- Connect connectors (1) and lock.
Removing airbag sensor from the front door
- Unlock plug connection (1) and disconnect.
- Turn the airbag sensor (2) on the front door in arrow direction and remove.
Installing airbag sensor in the front door
- Position the airbag sensor (2) on the front door and lock in the arrow direction.
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE FRONT MODULE BRACKET .
- Refer to INSTALLING OUTER WINDOW CHANNEL STRIP .
- Refer to INSTALLING THE OUTSIDE REARVIEW MIRROR .
- Refer to PARTIALLY INSTALLING THE COVER ON THE INSIDE OF THE WINDOW FRAME .
- Refer to INSTALL DOOR TRIM PANEL .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .