Installing the servomotor for the eccentric shaft (cylinder head removed)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 BMW M340i xDrive, 2024 BMW M340i, 2023 BMW M340i xDrive, 2023 BMW M340i, and 2022 BMW M340i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Replace seal (1) .
Parts: Gasket

Courtesy of BMW OF NORTH AMERICA, INC.
Press the seal (1) up to the limit position on the housing.

Courtesy of BMW OF NORTH AMERICA, INC.
Grease the gearing (1) of the servomotor (2) for the eccentric shaft in marked area.
CONSUMABLE DESCRIPTION

Lubricating grease Longtime PD-1 400 g, Cartridge 83192160340

Courtesy of BMW OF NORTH AMERICA, INC.
Clean sealing surface (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the servomotor (1) for the eccentric shaft up to the stop.
Turn the servomotor (1) for the eccentric shaft with a commercially available Allen wrench (2) with 4 mm in arrow direction until the servomotor (1) lies on the cylinder head for the cylinder head.

Tighten down screws (3) .

TIGHTENING TORQUE SPECIFICATION

Electrical servomotor to cylinder head
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.