11 11 ENGINE BLOCK (M340i, M340i xDrive)
1111 TIGHTENING TORQUE OVERVIEW
| Main bearing cap to crankcase | ||
| M10x85 Replace screws. |
1. tightening torque | 25 Nm |
| 2. Angle of rotation | 65° | |
| 3. Angle of rotation | 65° | |
| 4. Unscrew all screws. | ||
| 5. tightening torque | 25 Nm | |
| 6. Angle of rotation | 65° | |
| 7. Angle of rotation | 65° | |
| Special tool 11 8 930 to special tool 00 2 320 | ||
| M14x35 | tightening torque | 160 Nm |
| Special tool 2 413 082 to special tool 00 2 320 | ||
| M12x65 | Tightening torque | 100 Nm |