Installing the center cowl upper part

• Position the center cowl upper part (1)  .
• Tighten the screws in the marked areas.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Cowl upper part to bottom cowl
  	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Version with mild hybrid technology: 

  Clip line (1)  into the holders (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
• Install the tension strut (3)  on the shock tower.
• Tighten down screws (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Tension strut on bulkhead
  M10x25 screw	Tightening torque	56 Nm

• Replace screws (2)  .

  Parts:  Screws

• Tighten down screws (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .