Install A-pillar trim panel
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS ON HANDLING AIRBAG SYSTEM COMPONENTS/GAS GENERATORS .
NOTE:
RISK OF DAMAGE
Damage to the head airbag .
Improper use of a tool when removing the trim panel may damage the head airbag .
Damage to the head airbag .
Improper use of a tool when removing the trim panel may damage the head airbag .
- Do not use sharp-edged tools when removing the trim panel.
Check
- Check the snap-in lug (1) of the cover (2) for damage.
Result
» Snap-in lug is damaged.
Measure
- Replace cover.
Check
- Check the clips (1) for damage and replace if necessary.
- Check guides (3)
for damage.
Result
» The guide is damaged.
Measure
- Replace the A-pillar trim panel.
- Insert the A-pillar trim panel (3) downwards and clip in with the clips (4) .
- Tighten down screw (2)
.TIGHTENING TORQUE SPECIFICATION
A-pillar trim panel to body Sheet metal screw
4.8X38Tightening torque 2.6 Nm - Clip in the cover (1) .