Installing the alternator
- Slightly push back the threaded support sleeve (2) in the direction of arrow to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support sleeve (2) .
- Press back the threaded support bushing (2) using the bolt (1) .
- Unscrew the screw (1) from the threaded support bushing (2) .
- Insert and install the alternator (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Alternator on component carrier | ||
| M10x75 | tightening torque | 38 Nm |
| M10x125 | tightening torque | 38 Nm |
| M10x90 | tightening torque | 38 Nm |
- Tighten nut (1) .
TIGHTENING TORQUE SPECIFICATION
| Positive battery cable to the alternator | ||
| M8 | tightening torque | 19 Nm |
- Connect connectors (2) and lock.
The connector (2) must engage audibly.
Follow-up work
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to IF INSTALLED: INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .