Installing the adapter for the engine ventilation line with the heating element on the exhaust turbocharger

NOTE: RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

NOTE: RISK OF DAMAGE
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .

Do not use any metal-cutting tools.

NOTE: TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.

Clean sealing surface (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

Replace the seal (1) using the special tool 0 496 714 (00 9 030) .
Parts: Seal

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the connecting brackets (2) with the heating element at the exhaust turbocharger.
Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATION

Engine ventilation line adapter with heating element on exhaust turbocharger
M6x26 screw	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING CHARGE AIR LINE .
Refer to INSTALLING CLEAN AIR PIPE .
Refer to INSTALLING ENGINE VENTILATION LINE .
Refer to INSTALLING INTAKE FILTER HOUSING .
Refer to INSTALLING FAN COWL .
Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
Refer to INSTALLING UPPER CROSS CONNECTION .
Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
Refer to IF INSTALLED: INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT (PARTIALLY REMOVED) .
Refer to INSTALLING THE FRONT HOOD SEAL .
Refer to INSTALLING ACOUSTIC COVER .