Replacing the intake plenum
- Loosen screw (1) .
- Remove the boost pressure sensor (2) .
- Guide out and remove holder (3)
.
- Loosen clamp (1)
.
- Loosen clamp (1)
.
- Remove screws (arrows).
- Remove the throttle bodies (1)
.
- Replace sealing ring (1)
.
Parts: Sealing ring
- Replace sealing ring (1)
.
Parts: Sealing ring
- Feed in and install the throttle body (1) .
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATION
| Throttle body to intake plenum | ||
| M6X50 | tightening torque | 7 Nm |
- Secure clamps (1) .
- Secure clamps (1)
.
- Check sealing ring (1)
for damage and, if necessary, replace it.
Parts: Sealing ring
- Apply a thin coat of lubricant to the sealing ring (1)
of the boost pressure sensor.
- Insert and install the holder (3) .
- Insert and install the boost pressure sensor (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Boost pressure sensor to intake plenum | ||
| TS6X20 | Tightening torque | 5 Nm |