Installing coolant pumps
- Feed in and install the coolant pump (2) .
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Coolant pump to component carrier M6x20 Tightening torque 8 ± 1 Nm - Replace the belt pulley (1)
.
Parts: Belt pulley
The belt pulley (1) is included in the repair kit.
Feed in and install the belt pulley (1) .
- Replace the bolts (arrows).
Parts: Screws
The screws (arrows) are included in the repair kit.
- Hand-tighten the screws (arrows).
Follow-up work
- Refer to INSTALLING THE FLANGE SUPPORTS ON THE COMPONENT CARRIER .
- Refer to INSTALLING COOLANT LINE BETWEEN THE COOLANT PUMP AND CYLINDER HEAD .
- Refer to INSTALLING THE DRIVE BELT FOR THE COOLANT PUMP .
- Refer to TIGHTENING BELT PULLEY .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to IF INSTALLED: INSTALL UNDERBODY PROTECTION FOR THE STEERING .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .