Installing the rear door trim panel

Replace the clips (1) .
Parts: Clips

The clips (1) must not be engaged. The disengaged state is shown .

Courtesy of BMW OF NORTH AMERICA, INC.
Press the inner door handle (2) in a closed direction.
Feed in the Bowden cable for the inner door handle (2) and clip in at the detent (1) .
Connect and lock the present connectors.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the door trim panel (1) from the top into the inner window recess finisher strip.
Carefully clip in the door trim panel (1) at the clips (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1) .

TIGHTENING TORQUE SPECIFICATION

Door trim panel to door
Screw TS5x20	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Check the detents (1) for damage, if necessary, replace trim (2) .
Check the guides (3) for damage, if necessary, replace the trim (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Pull the door opener (1) .
Fit the trim (2) and clip in with the detents (3) .

Courtesy of BMW OF NORTH AMERICA, INC.