Adjust the lower part of the tailgate lock lower section

Check 

• Check the gap dimensions between the trunk lid and bumper cover (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

Gap dimension trunk lid to rear bumper panel
1 trunk lid; 2 rear bumper panel Courtesy of BMW OF NORTH AMERICA, INC.	a	5.1 +1.8-1.8 mm

Result 

» Gap dimension does not correspond to the specification.

Measure 

• Adjusting tailgate lock.

• Lever out the covers (1) with a suitable screwdriver and remove.
• Loosen screws (2) until the tailgate lock can be shifted.
• Adjust the trunk lid lock in such a way that the tailgate has the predefined gap dimension to the bumper cover.

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).

• Install and clip in the covers (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Adjust the stop pad (1) by twisting in arrow directions.

Courtesy of BMW OF NORTH AMERICA, INC.