Install upper cross connection

• Set and position the upper cross connection with holders (3)  from above.
• Tighten screws (1)  and (2)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Cross connection, top
  M8x20	Tightening torque	28 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Cross connection, top
  M6x20	Tightening torque	11.8 Nm

• Attach Bowden cable (1)  at the upper cross connection.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in housing (1)  for the coupling of the Bowden cables.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
• Refer to INSTALL THE FRONT HOOD SEAL .