Installing the auxiliary coolant pump
- Position auxiliary coolant pump (2) on holder.
- Lock coolant hose (1)
and connect to the auxiliary coolant pump (2)
.
- Lock coolant hose (3) and connect to the auxiliary coolant pump (2) .
- Secure auxiliary coolant pump (2) with the clamps (4) .
- Connect connector (1) .
Follow-up work
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to FASTENING CHARGE AIR LINE TO THE THROTTLE BODY .
- Refer to INSTALLING THE HOLDER FOR THE DME CONTROL UNIT .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR .
- Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
- Refer to FILLING THE HIGH-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE FIREWALL UPPER PART .
- Refer to INSTALLING THE TENSION STRUT ON THE STRUT TOWER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING CIRCUIT .
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .