LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2021 >> 230i 2D Convertible >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes -- Repair (F22 & F23) >> 34 00 Brakes, General >> 34 00 027 Replacing fluid in brake system (M Sport brake) (2' Series coupe and convertible, 2017-2021)

34 00 027 Replacing fluid in brake system (M Sport brake) (2' Series coupe and convertible, 2017-2021)

NOTE: READ AND COMPLY WITH GENERAL NOTES .
The capacities are oil change quantities. See "Fluid Capacities" tab for the selected vehicle. (capacities)

Necessary preliminary work: 

CAUTION: When carrying out repair work to the brake system, follow the procedure set out in BLEEDING BRAKE SYSTEM WITH DSC .
Use only BMW-approved brake fluids, see BMW OPERATING FLUIDS .

Connect bleeder unit to expansion tank (1) and switch on.

G09877844Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Follow the applicable machine manufacturer's operating instructions.
Charging pressure should not exceed 2 bar.

Completely flush brake system, rear  .

Connect tank ventilation line (1) with collecting vessel to vent valve on rear right  brake caliper.

G15356281Courtesy of BMW OF NORTH AMERICA, INC.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Carry out the same procedure on the rear left  wheel brake.

Completely flush brake system, front right outer  .

G10095758Courtesy of BMW OF NORTH AMERICA, INC.

Connect tank ventilation line (1) with collecting vessel to vent valve on front right outer brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Completely flush brake system, front right inner  .

G10095759Courtesy of BMW OF NORTH AMERICA, INC.

Connect tank ventilation line (1) with collecting vessel to vent valve on front right inner brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Carry out the same procedure on the front left wheel brake  .

NOTE: The clutch slave cylinder must be scavenged in vehicles with manual gearbox.

Switch off bleeder unit and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to "Maximum" level.

Close expansion tank.

NOTE: Pay attention to seal (1) in sealing cap.
G13796592Courtesy of BMW OF NORTH AMERICA, INC.