1235 ELECTRICAL MACHINES (i3 base)
1235 TIGHTENING TORQUE OVERVIEW
| Electrical machine electronics (EME) support to electrical machine | ||
| M8 | Tightening torque | 19 Nm |
| High-voltage cable to electrical machine electronics (EME) | ||
| M8 Replace screws. |
Tightening torque | 14 Nm |
| Lower section of connector to upper section of connector (rotor position sensor) | ||
| Tightening torque | 2 Nm | |
| Potential equalization line to electrical machine | ||
| M6 | Tightening torque | 8 Nm |
| Rotor position sensor to bearing cap | ||
| M5 Replace screws. |
Tightening torque | 4.5 Nm |
| Service cap to electrical machine | ||
| M6 | Tightening torque | 10 Nm |
| Stop pad to Drive module | ||
| M6 | Tightening torque | 12 Nm |