51 11 158 Replacing base plate for number/license plate

Only use the vehicle-specific number plate baseplate.

The installation of other license plate baseplates is not permissible.

Refer to Service Information MOUNT LICENSE PLATE .

The license plate must be mounted exactly on the number plate baseplate.

If a number plate baseplate is not offered for the corresponding national-market version, the license plate must be mounted directly on the bumper using a drilling template

Incorrect assembly leads to a malfunction of the sensors of the driver assist systems.

NOTE: Schematic diagram is example of I01 Japan national-market version.

Unscrew the screws (1).

Tightening torque 51 11 8AZ .

Remove holder (2) towards front.

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing bumper:

Drill out marks (1) on bumper to 10 mm.

Courtesy of BMW OF NORTH AMERICA, INC.

Position support (1) with centering (2) on bumper.

Screw in screws (3).

Tightening torque 51 11 8AZ .

Courtesy of BMW OF NORTH AMERICA, INC.