Installing transmission cross member

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Transmission cross member to rubber mounts
M12	tightening torque	68 Nm

Tighten the screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Transmission cross member to body
M8	Tightening torque	19 Nm

Remove the transmission jack.
Install the line.
Fasten the line with the clamps (1) to the transmission cross member (2).

Courtesy of BMW OF NORTH AMERICA, INC.