Removing wiring harness section for the ignition system of cylinder bank 1
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE INTAKE FILTER HOUSING ON THE LEFT .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE RIGHT INTAKE SILENCER BRACKET .
- Refer to REMOVING IGNITION COIL OF CYLINDER BANK 1 .
- Refer to REMOVING THE RIGHT UNFILTERED-AIR DUCT .
- Refer to REMOVING COVER FOR THE RIGHT DME CONTROL UNIT .
Precondition
6135...
- Unlock and disconnect the plug (1).
- Unclip wiring harness mounting (2).
- Unclip the wiring harness at the holders (1).
- Unclip the wiring harness at the holder (1).
- Unclip wiring harness mounting (2).
- Unclip wiring harness mounting (1).
- Unlock and disconnect the plug (3).
- Release the nut (5).
- Lay the grounding point (4) to one side.
- Loosen screw (1).
- Unlock and disconnect the transmission wiring harness at the snap-in lug (1).
- Unlock and disconnect the plug (3).
- Release the nut (4).
- Lay the grounding point (2) to one side.
- Unlock and disconnect the ignition wiring harness (1).
- Unclip the wiring harness at the snap-in lug (1).