Install luggage compartment wheel arch trim panel

• Open the flap (1) and hook the Bowden cable (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the Luggage compartment wheel arch trim panel (1) on the clips (2) and clip it in.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Luggage compartment wheel arch trim panel on body
  screw	Tightening torque	3.0 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivet (2).
• Clip in the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING D-PILLAR TRIM PANEL .
• Refer to INSTALLING COVER OF THE SEAT BELT FINISHER STRIP .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to INSTALLING THE BATTERY COVER .
• Refer to INSTALLING COVER FOR THE SIDE MEMBER .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING THE STORAGE SHELF .