Shifting vehicle into normal position
- Only on vehicles with air spring system: Perform ride height adjustment with diagnostic system.
- Check vehicle interior and trunk (including luggage compartment well) for load status, if applicable, unload vehicle.
- Lay prescribed DIN load into the vehicle.TECHNICAL DATA SPECIFICATION
DIN normal position loading Vehicle has a full tank.
Vehicle is completely assembled.Per front seat (seat in center position) 68 kg On the center rear seat 68 kg Centered in the trunk 21 kg - Only on vehicles with air spring system:
After the vehicle has been loaded, start the engine and wait until the vehicle ride height has been adjusted.NOTE: (The doors must be closed)