Installing guide for rear center bumper cover

• Position guide for rear center bumper cover correctly (2)  .
• Tighten nuts (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper guide, rear
  Nut	Tightening torque	6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper guide, rear
  Nut	Tightening torque	6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the right and left side.
• Install the cover (2)  .
• Mount the expanding rivets (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE REAR DIFFUSER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
• Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
• Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
• Refer to INSTALLING RIGHT BACKREST SIDE SECTION .