Install the rear top cross connection

• Feed in and position the rear top (3) cross connection.
• Tighten down screws (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear cross connection at the top of the hood lock support
  screw	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rear top cross connection to wheel arch carrier support
  M10x35 screw	Tightening torque	56 Nm

• Clip the vehicle wiring harness (1) onto the rear top cross connection (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT  and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .