Installing catalytic converter near the engine above cylinder bank 1

• Replace V-ribbon clips (1).

  Parts:  V-ribbon clips

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace seals (1).

  Parts:  Seals

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the catalytic converter (1) near the engine.
• Position V-clip (3).
• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Catalytic converter to exhaust turbocharger
  V-band clamp Replace V-band clamp.	Tightening torque	14 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Catalytic converter to cylinder head
  screw	Tightening torque	21.4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Catalytic converter to cylinder head
  screw	Tightening torque	21.4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Slide the V-clip (2) towards the bottom onto the catalytic converter near engine.
• Position V-clip (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Top catalytic converter to bottom catalytic converter
  V-band clamp Replace V-band clamp.	Tightening torque	14 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  Checking the screw connection of the V-ribbon clips 

  NOTE: TECHNICAL INFORMATION 
  The V-ribbon clip must be replaced! Reusing it is not permitted.
• Replace the V-ribbon clip (1).

  Parts:  V-band clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Check 

• Check if the screw connection of the V-band clamp is too loose.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The screw connection is too slack. If a gap can be seen between the ends of the V-ribbon clips.

Measure 

• Loosen the screw and tighten again.

Check 

• Check if the screw connection of the V-band clamp is too tight.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The screw connection is too tight. The ends of the V-ribbon clip are not positioned parallel.

Measure 

• Release the screw and replace the V-ribbon clip.

  Parts:  V-band clamp

• Make sure that the ends of the V-band clamp are parallel to each other.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING HEAT SHIELD, TOP .
• Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 1 TO 4 .
• Refer to INSTALLING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 5 TO 8 .
• Refer to INSTALLING THE CROSSING OF THE TRANSMISSION WIRING HARNESS .
• Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE .
• Refer to INSTALLING BRACKET FOR RIGHT INTAKE SILENCER .
• Refer to INSTALLING OIL FILLER NECK .
• Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 1 .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
• Refer to INSTALLING THE OXYGEN SENSOR MONITOR FOR CYLINDERS 1 TO 4 .
• Refer to FASTENING THE ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .