Install the rear window

Check the hook and loop tape (Dual Lock tape) (1) on the body and the rear window for damage and availability.
A damaged or missing hook and loop tape (Dual Lock tape) (1) must be replaced.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the spacer buffer (1) for damage and availability.
Damaged or missing spacer buffers (1) must be replaced.

Courtesy of BMW OF NORTH AMERICA, INC.
Keep (2) glue cartridges ready.
Prepare (1) glue cartridge with the standard nozzle (C).
Apply bead joint in area (1) .
Apply adhesive bead within the mark on the rear window

Courtesy of BMW OF NORTH AMERICA, INC.
Carefully perform the following actions on the rear window (1) with the suction lifter
- Bring it parallel to C-pillar
- apply and press at the bottom on the seal
- Align sides evenly
- evenly press all around and snap-in at the hook and loop tapes (Dual Lock tape)
Make sure that the seal (2) lies evenly on the tailgate (3) .
Secure rear window (1) with adhesive tap on the roof.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove adhesive tape (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the cable to the cable brackets (3) .
Connect connectors (2) and lock.
Tighten down screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the cable to the cable brackets (3) .
Connect connectors (2) and lock.
Tighten down screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work