Secure the wishbone at the swivel bearing
- Position the wishbone (2) on the swivel bearing (3).
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
Counter-hold at the Torx socket.
TIGHTENING TORQUE SPECIFICATIONWishbone to swivel bearing M16
Replace nut.Joining torque 100 Nm Angle of rotation 90° - Make sure there is sufficient distance (1) between the wheel speed sensor (2) and the output shaft (3).
- Position output shaft (3) on the swivel bearing (4).
- Clip in the cable for the wheel speed sensor (2).NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
- Clip the cable for the Dynamic Damping Control into the holders (1).NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
- Position connecting rod (2) at the ride height sensor.
- Tighten nut (1).TIGHTENING TORQUE SPECIFICATION
Jointed rod to ride height sensor M6 Tightening torque 8 Nm