Installing both actuators

• Check seal (1)  for damage, replace the seal (1)  on the actuator (2)  if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position both actuators.
• Connect and lock both connectors (1)  .
• Ensure that the connectors (1)  engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position special tool 2 360 895  correctly on the actuator (1)  of the exhaust side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  on the exhaust side and use the special tool 2 360 895  to turn in the arrow direction until the stops rest on the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position special tool 2 360 895  correctly on the actuator (1)  of the intake side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  on the intake side and use the special tool 2 360 895  to turn in the arrow direction until the stops rest on the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE SECOND END PANEL UNDERNEATH .
• Refer to INSTALLING THE COWL UPPER PART .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE REAR HOOD SEAL .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .