Installing the connecting branches on the turbocharger for the cylinders 1 to 3
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
- Do not use any metal-cutting tools.
- Check the sealing ring (1) for damage, replace the connecting bracket (2) for cylinders 4 to 6 if necessary.
- Check the sealing ring (1) for damage and replace the sealing ring (1) as needed.
- Wet sealing ring (1) with approved lubricant grease.
INSTALLATION AID SPECIFICATION
| Lubricants G14 | 900 ml, Can | 83232360412 |
- Clean the sealing surface (1) using special tool 0 495 102 (11 4 470)
.
- Guide in and install the connecting bracket (1) for cylinders 1 to 3.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Connecting brackets on turbocharger | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Connecting brackets on turbocharger M6 tightening torque 8 Nm - Connect and lock the tank vent line (1).
The tank vent line (1) must engage audibly.
- Connect and lock connectors (1) and (2).
The connectors (1) and (2) must audibly engage.
Follow-up work
- Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 1-3 .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .