Install charge air pipe cylinders 4 to 6

• Check seal (1) for damage, replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock clamp (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Thread in charge air pipe cylinders 4 to 6 (2) and install.
• Make sure that the charge air pipe cylinders 4 to 6 (2) audibly engage.
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING CHARGE AIR DUCT OF CYLINDERS 4 TO 6 .
• Refer to INSTALLING CHARGE AIR DUCT OF CYLINDERS 1 TO 3 .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING FRONT CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .