Install the bottom deformation element
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Feed in the bottom deformation element (2) .
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Support/Deformation element to vertical connection | ||
|---|---|---|
| M6x20 screw | tightening torque | 11.8 Nm |
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Support/Deformation element, bottom to front subframe adapter | ||
|---|---|---|
| M8x60 screw | tightening torque | 19 Nm |
Follow-up work
- Refer to INSTALLING RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
- Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .