Install catalytic converter

Prepare for the installation of the catalytic converter

Replace the V-ribbon clip (1).
Parts : V-band clamp

Courtesy of BMW OF NORTH AMERICA, INC.
Replace gasket (1).
Parts : Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install catalytic converter.
Lock clamp (1).
The clamp (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten V-band clamp (1).

TIGHTENING TORQUES SPECIFICATION

Catalytic converter to exhaust turbocharger
V-band clamp Replace V-band clamp.	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Catalytic converter to holder
M8 copper-plated nut Replace nut.	Tightening torque	28 Nm
M8 zinc-plated nut	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

If installed: Installing differential pressure sensor

Installing differential pressure sensor

TIGHTENING TORQUES SPECIFICATION

Differential pressure sensor to holder
Hexagon nut M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace pressure hose (2)
Parts : Pressure hose
Connect the pressure hose (2) to the differential pressure sensor (4) in the direction of the arrow until the stop.
Connect and lock the connector (1).
The connector (1) must engage audibly.

Follow-up work