Install the oil vacuum pump
- Check guide sleeves (1) for damage and replace if necessary.
Parts: Guide sleeves
- Make sure the sealing ring (1) is installed correctly.
The sealing ring (1) must not be damaged or missing.
- Insert oil vacuum pump (1) into the drive chain (2).
- Position oil vacuum pump (2) correctly on the guide sleeves.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Oil vacuum pump to crankcase | ||
| M8 Replace screw. |
Joining torque | 15 Nm |
| Angle of rotation | 45° | |
Follow-up work
- Refer to REFITTING ENGINE OIL PAN .
- Refer to ATTACHING THE LEFT AND RIGHT TENSION STRUTS ON THE SWIVEL BEARING .
- Refer to SECURE THE WISHBONE ON THE LEFT AND RIGHT ON THE SWIVEL BEARING .
- Refer to SECURING THE TIE ROD ON THE LEFT AND RIGHT OF THE SWIVEL BEARING .
- Refer to SECURE THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to FASTEN ELECTRIC COOLANT PUMP AND COOLANT HOSES TO THE FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to TAKING ENGINE OUT OF INSTALLATION ORIENTATION .
- Refer to INSTALLING THE COVER PANELS ON THE FRONT AXLE ON THE RIGHT AND LEFT .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to TIGHTENING THE OIL FILTER CAP
- Refer to TOPPING UP THE MOTOR OIL
- Refer to RECONNECTING ALL BATTERY GROUND LEADS
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
- Refer to INSTALLING ACOUSTIC COVER .