Adjusting Headlights
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
TECHNICAL INFORMATION
Notes on the headlight adjustment are a fundamental requirement for these repair instructions and must be complied with at all times.
For ADDITIONAL INFORMATION see: 63 10... Test prerequisite for the headlight adjustment
Notes on the headlight adjustment are a fundamental requirement for these repair instructions and must be complied with at all times.
For ADDITIONAL INFORMATION see: 63 10... Test prerequisite for the headlight adjustment
- Adjust the headlights at the adjusting screws (1) and (2).
A definite allocation of adjustment screws is not possible.
The adjusting screw (1) is primarily used for height-adjustment.
The adjusting screw (2) is primarily used for lateral adjustment.
- Adjust the height at the adjustment screw (1).
- US version:
Only carry out lateral adjustment setting if the plug on the adjustment screw for lateral adjustment is missing or damaged.
If applicable, remove the damaged plug (see ADDITIONAL INFORMATION ).
- Make the lateral adjustment at the adjustment screw (2).
- Perform reference run. To this end, switch off the headlight and switch it back on.
- Check the headlight and adjust if necessary.
- US version: If the lateral adjustment has been checked or corrected: replace the plug and press it into the adjustment screw for the lateral adjustment without damaging the plug (see ADDITIONAL INFORMATION ).