Installing the oil-level sensor
Prepare the oil-level sensor
- Replace sealing ring (1).
Parts: Sealing ring
- Insert and install the oil-level sensor (2).
- Tighten the nuts (arrows).
TIGHTENING TORQUES SPECIFICATION
| Oil-level sensor to oil sump | ||
|---|---|---|
| M6 | Joining torque | 2.5 Nm |
| Tightening torque | 8.5 Nm | |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
- Feed in the cover (1) in the marked area and install.
Follow-up work
- Refer to RAISING THE FRONT AXLE SUPPORT AND FASTEN IT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to FASTENING ELECTRIC COOLANT PUMP AND COOLANT HOSES TO THE FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to TAKING ENGINE OUT OF INSTALLATION ORIENTATION .
- Refer to INSTALLING THE COVER PANELS ON THE FRONT AXLE ON THE RIGHT AND LEFT .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS
- Refer to INSTALLING ACOUSTIC COVER .