Lower front subframe
NOTE:
RISK OF DAMAGE
Failure to comply with the specification .
Component damage .
Failure to comply with the specification .
Component damage .
- All specifications must be observed and complied with.
- When lowering the front subframe, ensure sufficient distance between the steering gear (1) and the output shaft (2).
- Secure the front subframe (1) with special tool 0 496 080 (33 5 206) to special tool 0 495 817 (31 5 251)
.
- Lower the front subframe (1) with the universal jack by dimension (A).
Dimensions (A) = maximum 15 cm