Installing the coolant supply line, part 1, on the auxiliary coolant pump
- Replace the sealing ring (1) on the coolant feed line part 1 (3) with the special tool 0 496 714 (00 9 030)
.
Parts: Sealing ring
- Check the sealing ring (2) for damage, replace the coolant feed line part 1 (3) if necessary.
- Feed in and install the coolant feed line part 1 (3).
- Make sure that the lock (1) engages audibly.
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Coolant feed line part 1 on crankcase M6X16 Tightening torque 8 Nm
Follow-up work
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .