Replacing the rear bumper cover
Preliminary work
- Refer to REMOVING THE FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
- Refer to REMOVING FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON RIGHT .
- Refer to REMOVING BOTH TAIL LIGHTS FROM THE SIDE PANEL .
- Refer to REMOVING LEFT AND RIGHT REAR REFLECTORS .
- Refer to REMOVING REAR BUMPER PANEL .
- Refer to REMOVING THE COVER ON THE REAR BUMPER COVER .
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Unlock the detents (1).
- Remove the ultrasonic sensors (2) along with the wiring harness.
- Replace the bumper cover.
Parts: Bumper cover
- Install the ultrasonic sensors (2) along with the wiring harness and engage at the detents (1).
Follow-up work
- Refer to INSTALLING THE COVER ON THE REAR BUMPER COVER .
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
- Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .