Installing the cover on the rear bumper cover

• Fit the cover (1) and snap it in along the dotted line at the detents (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the right and left side.
• Install the ultrasonic sensor (2) and snap it in at the detents (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .