Installing both fog lights
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing the fog light
- Position the front fog lamp (3).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Fog light on bumper cover | |
| Hexagon screw | 3.5 Nm |
- Connect plug (1).
Follow-up work
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM .
- Refer to MOUNTING THE WHEEL .
- Refer to ADJUSTING FOG LIGHTS .