Install the Front Light Electronics right (FLER) control unit

NOTE: Description is for left component only. Procedure on the right side is identical.

Install the Front Light Electronics control unit

Check the seal (3) on the control unit for the Front Light Electronics (2) for damage and replace if necessary.
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the control unit for the front light electronics (2) in the headlight.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Frontal Light Electronics (FLE)
PT-SCREW 40x12	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work